The Buyback Guide Participating

Entitlement Ratio and Acceptance Ratio — The Two Numbers That Decide Everything

Entitlement is what you may tender. Acceptance is what actually gets bought. The gap between them is where most buyback expectations go wrong.

4 min readGuide 4 of 6Updated

Two ratios govern a buyback. One is published before you decide; the other only after. Confusing them is the most common way to be disappointed by an outcome that was entirely predictable.

Entitlement ratio — what you may tender

The entitlement ratio defines the guaranteed portion, expressed per share held on the record date.

A ratio of 1:9 means one share may be tendered for every nine held. Hold 900 shares, and your entitlement is 100.

It is stated in the letter of offer, and it is computed separately for the two categories:

  • Small shareholders — the reserved 15 percent, divided among the shares that category holds
  • General category — the remaining 85 percent, divided among everyone else

The two ratios are usually very different, and that difference is the whole point.

Acceptance ratio — what actually gets bought

The acceptance ratio is the percentage of tendered shares the company ultimately buys. Tender 100 shares, have 32 bought, and the acceptance ratio was 32 percent.

It is not knowable in advance, because it depends on how many other shareholders tendered. It is published after the offer closes, in the post-offer announcement.

The relationship between the two is simple: if everyone tenders exactly their entitlement, acceptance is 100 percent of entitlement. If many shareholders tender above their entitlement, the excess competes and acceptance falls. If many do not tender at all, acceptance can exceed entitlement — the shares you offered above your entitlement get taken up.

Why the small shareholder category is different

A small shareholder is one holding shares worth up to two lakh rupees on the record date, measured at the reference price in the regulations. The registrar makes the classification from the record-date holding; you cannot elect into it.

Fifteen percent of the offer is reserved for that group.

The arithmetic that follows is the single most useful thing to understand about buybacks. In most listed companies, shareholders below two lakh rupees hold well under 15 percent of the equity — often far less. So a reserved slice sized at 15 percent is being shared among a much smaller pool of shares.

The result is that acceptance ratios in the small shareholder category are routinely several times better than in the general category. It is common to see something like:

Category Entitlement ratio Acceptance ratio
Small shareholder 1 : 4 100%
General 1 : 22 41%

Same offer, same price, very different outcomes.

The threshold question

Because the classification is made on record-date value, holding just under two lakh rupees before an expected buyback puts you in the better category.

This is legitimate and widely done. Two caveats are worth stating plainly. It means holding a smaller position in the company, which should be a decision you are comfortable with independently. And “two lakh rupees” is measured at a prescribed reference price on the record date, not at yesterday’s close — leave headroom rather than sitting exactly on the line.

Tendering above your entitlement

There is no downside to it, and there is frequently an upside.

Shares tendered above the entitlement go into a second round: they are considered only after all entitlements are satisfied, and only if the offer is not fully taken up. In buybacks where institutional holders sit out — which is common — that second round can be substantially filled.

The only reason not to tender above your entitlement is that you want to keep the shares.

Working out what you might get

Before the offer:

  1. Read the entitlement ratio for your category from the letter of offer
  2. Apply it to your record-date holding
  3. Assume acceptance somewhere between 40 and 100 percent for small shareholders, and considerably lower for the general category
  4. Compute the premium on the accepted portion, and the tax on it
  5. Assume the unaccepted shares come back at a price below where they are today

After the offer, the post-offer announcement gives you the actual acceptance ratio — and it is worth reading even for buybacks you did not participate in, because it calibrates your expectations for the next one.

The number people forget

Acceptance is the ratio that decides whether the trade was worth it, and it is the one you cannot know when you decide.

That asymmetry is why buyback arbitrage is a real trade with real risk rather than free money, and it is what the next guide is about.

Frequently asked questions

Who counts as a small shareholder?

A shareholder whose holding on the record date is worth up to two lakh rupees, measured at the reference price prescribed in the regulations. The classification is made by the registrar from the record-date holding — you cannot choose it.

Why is the small shareholder acceptance ratio so much better?

Because 15 percent of the offer is reserved for a group that typically holds far less than 15 percent of the company. The reserved slice is large relative to the shares tendered into it.

Should I keep my holding just under two lakh rupees before a buyback?

It is a real and legitimate consideration where a buyback is expected, since the small shareholder category consistently gets a better acceptance ratio. It also means holding a smaller position in the company, which is a separate decision that should stand on its own merits.

Can acceptance be 100 percent?

Yes, in a buyback that is under-tendered — everything offered is bought. It happens more often than people expect, particularly in the general category of a large buyback where institutional holders choose not to participate.

Run this process at network scale.

BidFlow handles bulk applications, ASBA form printing, live subscription and GMP data, and one-click allotment checks across every branch.

Book a Demo
Chat with us