The IPO Guide Applying

How to Apply for an IPO in India — The Complete Walkthrough

What you need before you start, the three routes for submitting a bid, what happens to your money, and the timeline from application to shares appearing in your demat account.

4 min readGuide 10 of 26Updated

Applying for an IPO in India takes about three minutes once you have the prerequisites. Getting the prerequisites right is the part that trips people up.

What you need before you start

  • A PAN. Mandatory on every application, and it must match the PAN registered against your demat account exactly.
  • An active demat account with NSDL or CDSL, through any depository participant. Allotted shares can only be delivered there.
  • A bank account in your own name, with the full application amount available as a free balance. An overdraft or credit limit will not do.
  • A UPI ID linked to that bank account, if you plan to apply through a broker.

That is the entire list. There is no separate registration for IPOs.

The three routes

Through a broker, using UPI. The most common route for retail. You place the bid on your broker’s app, supply your UPI ID, and approve the mandate that arrives in your UPI app. Available up to the prescribed per-application ceiling, currently five lakh rupees.

Through your bank, using ASBA net banking. Log into net banking, find the IPO or ASBA section, select the issue, enter your demat details, quantity and price. The bank blocks the amount directly. This is the route for applications above the UPI limit, and it avoids the UPI mandate failure modes entirely.

On paper, through a broker or bank branch. Still permitted, and still used by broking desks that collect applications from clients across a branch network. The physical form carries the same fields and is uploaded to the exchange by the syndicate member.

Filling in the bid

Whichever route you use, the same fields have to be right:

  • Category. Retail if the application is up to two lakh rupees; non-institutional above that. Employees and shareholders of a listed parent may have their own reserved category.
  • Quantity. In multiples of the lot size. An application for anything other than a whole number of lots is invalid.
  • Price. Retail investors should tick cut-off, which means accepting whatever final price emerges. Naming a price below the eventual issue price gets your bid rejected at allotment.
  • Demat details. DP ID and client ID, exactly as they appear on your client master report. CDSL accounts are a single sixteen-digit number; NSDL accounts begin with IN followed by fourteen characters.
  • UPI ID or bank account, in the first applicant’s own name.

What happens to your money

Nothing is debited. Under ASBA, the amount is blocked in your own account under a lien and continues to earn interest.

The amount blocked is always the cap price multiplied by the lot size, even when you bid at cut-off and even if the issue eventually prices lower. If the final price comes in below the cap, the difference is released after allotment.

If you receive no allotment, the whole lien is simply lifted. There is no refund to wait for, because no money ever left.

The timeline

When What
Day 1–3 Bidding window, 10:00 a.m. to 5:00 p.m. each day
Day 3 Issue closes; brokers cut off earlier than the exchange
Day 4 Price set, allotment finalised, basis of allotment published
Day 5 Funds unblocked; allotted shares credited to demat
Day 6 Listing, starting with the special pre-open session

Practical advice that actually matters

Apply on day one or two, not the last afternoon. The final hours of an issue are when UPI mandates fail, banks time out and broker platforms slow down. Applying early costs you nothing — the money is blocked either way — and it leaves room to recover from a failure.

Approve the mandate immediately. The bid is not complete until the block is in place. A mandate sitting unapproved at the close is a rejected application.

Use the UPI ID tied to the funding account. Mismatches here are a leading cause of failed mandates.

Check your details against the client master report. A DP ID typed from memory is the most common technical rejection there is.

Never fund someone else’s application from your account. Third-party applications are prohibited and are rejected on detection, even when allotment would otherwise have been made.

After you apply

You get an application number on the acknowledgement. Keep it — along with your PAN and demat account, it is one of the three ways to look up allotment status on the registrar’s portal on allotment day.

If you change your mind, retail investors can revise or withdraw a bid at any time before the issue closes. Institutional and non-institutional investors cannot.

Frequently asked questions

Do I need a trading account to apply for an IPO?

Not strictly. You need a demat account to receive the shares and a bank account to fund the application. You can apply through your bank's net banking under ASBA without any broker. A trading account is needed to sell the shares afterwards.

How much money is actually taken from my account?

None, until allotment. The amount is blocked under a lien and stays in your account earning interest. Only the value of shares actually allotted is debited; the rest is released.

Can I apply for more than one lot?

Yes, up to the limit of your category — two lakh rupees for retail. But in an oversubscribed issue the retail draw works per application, not per lot, so a larger application does not improve your odds of getting something.

Can my spouse and I both apply?

Yes, provided each has their own PAN, their own demat account, and funds the application from an account in their own name. That is the legitimate way to increase the number of entries in the draw.

Run this process at network scale.

BidFlow handles bulk applications, ASBA form printing, live subscription and GMP data, and one-click allotment checks across every branch.

Book a Demo
Chat with us